LIPO Battery 11.1V 1800mAh LB-012
過充電防止、過放電防止の保護回路内蔵。
>>>リチウムポリマーバッテリー LB シリーズ マニュアル V1.20(PDF) 2021-10-22更新
PCM is incorporated to protect the battery from overcharge, discharge, and excessive current.
Lithium Polymer rechargeable battery for the ROBOTIS OP series.
Cannot be used for PREMIUM/GP because the connector and size differs.
Can be recharged with LBC-010 Battery Charger.
| LIPO 11.1V 1800mAh LB-012 | 1 |
|---|
* Battery Charger (LBC-010), sold separately
| Weight | 106g |
|---|---|
| Size | 88mm x 35mm x 26mm |
| Voltage | 11.1V |
| Capacity | 1800mAh |
| Discharge Rate | 5C |
| Etc. | PCM built-in (overcharge, discharge, excessive current protection) |
Product : DARwIn-OP, ROBOTIS OP2, ROBOTIS OP3, TurtleBot3, OpenCR
Charger : LIPO Battery Charger LBC-010
*NOT compatible with other CM-series controllers.
Do NOT charge the battery when the battery is connected to the robot
When storing away the battery for a long time, make sure the battery life is somewhere around 50%.
Do not store it in wet or hot places.
※ The warranty for the LIPO 11.1V 1800mAh LB-12 is 6 months.
Do not drop or fold parts of the battery or its parts.
Do not use the product when charging.
Do not apply heat, water or any other liquid on the battery.
Do not place in the microwave, washing machine or dryer.
Do not use damaged batteries. (inflated,deformed, damaged, etc)
Do not short circuit the polarity.
Do not take the battery apart.
When charging, make sure the battery is connected into the correct polarity.
Do not charge when the battery is hot. Please charge after it has cooled off.
When the battery is not being used or fully charged, please do not have it connected to a controller.
Do NOT charge the battery when the battery is connected to the controller.
